How to get sanding dust out of panel lines?

[David Hingtgen]

Is there any quick and easy way to get all the sanding dust out of fine panel lines after a sanding session? It's even worse if you've been wet-sanding. The stuff just sticks like glue sometimes.

[Akula]

I use a toothbrush... i find that going over the model a few times really gets the crud out.

[bhop]

I use a fat paintbrush. It's a little softer than a toothbrush, but I guess either would work.

[wm cheng]

Make sure your brush is wet too - otherwise its like sandpaper - the water really helps lubricate.