tank Posted January 19, 2004 Posted January 19, 2004 hi guys i would like to know on how to paint your mecha and maintain a smooth surface. coz i only use brushes and it always leaves some brush marks on the surface Quote
Ranger565 Posted January 20, 2004 Posted January 20, 2004 I am sorry I use an Air Brush, I use Paint brush for smaller jobs and fine detail Quote
kanata67 Posted January 20, 2004 Posted January 20, 2004 Getting your paint the correct consistency is a large part of it, wheteher diluting water based acrylic or just shaking the heck out of the paint jar for a while. Using good quality brushes is another large part. Sable hair works sooooo much better than nylon. Lastly... I find a final wash seems to blend the few brush lines remaining quite well. My painting looks like it was airbrushed but my color schemes look like I smoke to much mary jane Quote
dyowelb Posted January 20, 2004 Posted January 20, 2004 (edited) * thin your paint a little than normal. * apply thin layer at a time. * use a good brush. * brush in one direction. * use the right size for the right job (small brush for small job etc...) i've hand painted 3 patlabor 1/60 and they look nice after following the rules above - application wise but color wise, i suck mixing color. fyi, i'm using those cheap testor brushes Edited January 20, 2004 by dyowelb Quote
Mallet21 Posted January 20, 2004 Posted January 20, 2004 I would lay down your base (your models most dominate color) coat using a rattle can of spray paint. Its just too hard to get a smooth finish on a model using a brush and if you don;t have the means to get an airbrush the next best thing would be spray paint. The brushes would be great for details and smaller parts as was stated earlier. Quote
kanata67 Posted January 21, 2004 Posted January 21, 2004 added another pic to the how to custom thread tank. http://www.macrossworld.com/mwf/index.php?...24&t=4586&st=0& another pic of wash Quote
kanata67 Posted January 23, 2004 Posted January 23, 2004 in responce to your pm question about painting before assembly or after... Different people do it different ways. Painting parts while on the spruce is easier in many ways as it's easier to prime front and back, easier to hold steady while you paint, and easier to reach parts/areas that are almost impossible to reach once the part is assembled. You wil still have to do a touch up after you assemble it to cover the spots where parts were attached to the spruce. A problem I have encountered is that models painted before assembly can be structurally weaker if you do it wrong. Glue sticks best plastic to plastic. If you glue paint to paint parts often come apart. You can get around this by sanding paint/primer off the areas that glue will be applied to. I always recommend doing a dry fit [not using glue] to see how the parts go together and make sure they fit properly, before you actually assemble it with glue. Quote
tank Posted January 23, 2004 Author Posted January 23, 2004 hey thank alot kanata67 you really helped me alot Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.