Yamato 1/48 CAD Drawings

[nightmareB4macross]

If anyone out there has the full top, side, bottom, front, rear, or front schematic CAD drawing(s), it would be greatly appreciated.

Just PM me if you've got.

Thanks.

***OOPS. forgot to mention. I need them for he VF-1.

Edited August 10, 2007 by nightmareB4macross

[Crazy Canuck II]

Good luck. If you do get any Yamato CAD images, can you post them or send them to me? I'm looking for 1/48 vf-1 fighter & battroid as well as GBP-1S armor. I started a thead quite a while ago asking if anyone had Yamato CAD images, Graham replied that he has several, but had to check with Yamato if it was ok to give them out. Never did heard back from him. I PM'd him maybe a month or so ago, but again no reply. Maybe you'll have better luck than me.

Edited August 14, 2007 by Crazy Canuck II

[nightmareB4macross]

Good luck. If you do get any Yamato CAD images, can you post them or send them to me? I'm looking for 1/48 vf-1 fighter & battroid as well as GBP-1S armor. I started a thead quite a while ago asking if anyone had Yamato CAD images, Graham replied that he has several, but had to check with Yamato if it was ok to give them out. Never did heard back from him. I PM'd him maybe a month or so ago, but again no reply. Maybe you'll have better luck than me.

In the magazine section of MW you will find a few CAD drawing of the GBP-1S.

I just hope someone out there has an older mag with pictures of what we need. The pics should be around 2000-2001, or maybe 1999.