Sanity is Optional
-
Posts
5747 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Everything posted by Sanity is Optional
-
Calibre Wings 1/72 F-14D Diecast Macross Custom
Sanity is Optional replied to seti88's topic in Toys
From what I've read on these, the Hikaru seems to be generally worse (quality-wise) than the Roy, so it may just have been a specific run rather than a different factory. -
Shrug On the Bandai everything clipped on solidly, with the Arcadia I had bits constantly falling off while I was trying to get the legs lined up and pegged in. Which is odd, since the Arcadia I got new, and the Bandai I got used.
-
I have both, I actually found it easier to get the fast pack stuff on in fighter mode with the Bandai.
-
My arcadia YF-19 is the same way, fighter mode with all the fast pack stuff is a bit of a PITA to get lined up and locked in.
-
I think plastic cement works on that plastic. Otherwise just use superglue. [edit] I remember, I tried plastic cement on my Arcadia VF-1S Roy when one side of the backpack flap hinge broke. Had to use superglue to get it to stay.
-
You should be able to remove the stuck peg by drilling it out. I'd just replace the hardpoint with glue or plastic cement.
-
Or "veritech", or "robo technology".
-
What manufacturer is that from?
-
It'll pop back up, there's probably some delay though. I've picked up a few things where one or two popped back into stock as someone cancelled randomly.
-
Alright, about to let go of a Messer at HLJ. Edit: Order cancelled, good luck.
-
Sure, ought to be in about ~12min or so.
-
Anyone who missed a VF-31F Messer from the pre-orders, I'll be cancelling my HLJ pre-order at 2pm PST
-
Definitely Steiner for a Monster. To build in BT it'd need well over 100tons.
-
I'll let go of mine at HLJ tomorrow, got one from NY since their cost is quite a bit lower.
-
NY's page link went up before the valk was actually available.
-
NY is up.¥17580. edit: page exists, but is not yet up. https://www.nippon-yasan.com/figures/25206-macross-delta-dx-chogokin-movie-vf-31f-siegfried-messer-ihlefeld-hayate-immelman-custom-.html
-
NY's back up, no messer yet.
-
Well, if I don't cancel mine I'll take some measurements off the clips and put them up on shapeways for people.
-
Eh, picked one up from HLJ, since I can cancel later on.
-
Comes with Helmetless Hayate as the pilot and the Lil'Draken clips for the wings.
-
The only reason I can think of for a re-issue is to get people who skipped it the first time around. I'm on the fence if I want one or not, on the one hand I don't have a VF-31F yet, on the other hand there's a reason I skipped it the first time around.
-
New it was closer to 15000 yen as I recall. He got it shipped cheaper than mine was w/o shipping. It's a great rendition of the VF-2SS, but since there's a lot of anime magic involved in the transformation it can't be perfect. Worst part is the gap between the heat shield and cockpit in battroid.
-
It goes pretty fast, depending on what software you use.
-
You could combine the STLs into a single file, but it'd still need a lot of gap-filling.
-
This would be awesome. Need more versions of the YF-21 to go with my 2 (soon to be 3) versions of the YF-19.